5 Installation
P-56x Nanopositioners
PZ248E
Version: 1.0.0
25
Figure 9: Long lever and center of load on the side of the moving platform
Prerequisite
You have read and understood the General Notes on Installation (p. 17).
Tools and accessories
Screws of appropriate size and length (p. 42)
Suitable tools
Affixing the Load
Only affix loads to the threaded holes (p. 42) intended for this purpose and
with suitable screws. Observe the specified torque range (p. 43) while doing
so.
Affix the load so that it is centered and that the center of load is on the moving
platform.
5.5 Connecting the Adapter Cable to the P-56x (Only
P-56x.3CL Models)
Prerequisites
The adapter cable is
not
connected to the electronics.
Tools and accessories
Supplied E71000211 adapter cable (p. 12)
Connecting the adapter cable to the P-56x
Connect the Sub-D Mix connector (m) of the P-56x to the Sub-D Mix
connector (f) of the adapter cable.
