1x LED FRAME A
10x LED LIGHT BAR
1x SUPPORT FRAME
Contains driver
fixing bracket
1x LED FRAME B
2
4
1x LED DRIVER
Contains power output & dimming
female connectors and power supply
input male connector’
1
5
3
Fig4.
Fixture components
•
Always adhere to the local rules and regulations when installing or using the LED fixture.
•
Do not open or disassemble the LED fixture as it contains no serviceable parts inside. Opening or modifying
the LED fixture can be dangerous and will void the warranty.
•
Do not use the LED fixture when either the LED fixture or its power cord are damaged. Replace the power cord
with correctly rated cord only.
•
Modifications to the cabling can lead to unwanted electromagnetic effects which may make the product not
comply with legal requirements.
•
Do not expose the LED fixture to:
Condensing humidity, heavy mist or direct spray;
Ambient temperatures outside the specified range;
Dust and contamination;
Direct sunlight during use or HID light that may heat up the driver.
•
Always disconnect the LED fixture from mains before performing any maintenance.
•
Always allow for a cool down period of at least 20-30 minutes before touching the LED light bars. Touching
the LED bars when the fixture is lit or immediately after may result in burns!
•
Natural convection removes heat away from the heatsink. In order for the system too properly cool itself, at
least 5cm of space is required between the fixture and the roof of your grow area.
•
Do not use abrasive materials or aggressive cleaning agents to clean the LED fixture as this may damage the
secondary optics. Instead use a clean dry fabric/cloth.
•
Do not use the LED fixture near flammable, explosive or reactive substances. The LED fixture can reach tempera-
tures of 40ºC.
•
Do not use sulphur vaporizers or water misters.
•
The installation and use of the LED fixture is the responsibility of the end user. Incorrect use or installation can
lead to failure and damage to the LED fixture. Damage to the LED fixture and electronic circuitry as a result of
incorrect installation and use revokes the warranty.
5. CONTENTS
Mounting and installing the LED fixture must be in accordance with the applicable local laws and regulations.
WARNING!
The installer is responsible for correct and safe installation.
WARNING!
Ensure the local cabling can support the voltage and current requirements of the LED fixture.
WARNING!
Avoid coiled cords and keep mains leads separated to help prevent electromagnetic interference.
WARNING!
Do not connect or disconnect the LED fixture under load.
WARNING!
6. INSTALLATION
•
1 X 120V POWER SUPPLY CORD
•
2 X METAL CABLE HANGERS
•
1X MANUAL
Connects to SIGNAL IN
connector on Frame B
1X DIMMING CONTROLLER 0 -10V
Contains power inputs & dimming
self-locking male connectors
and control signal ports’