6.6
Connecting the LED fixture to the mains
•
Regularly check the LED fixture for dust or dirt build up. Clean if necessary. Contamination may cause
overheating and decreased performance.
•
Clean the outside of the LED fixture using a dry or damp cloth.
•
Regularly check the cords of the LED fixture to ensure it is undamaged.
•
The LED fixture is supplied with a 120V power cord for 120V power supply. 240V and 277V power cords
are not included and must be purchased separately.
•
Select the correctly rated cord for your mains power supply and connect driver power input socket to
switching gear/power supply.
•
Ensure the LED driver power supply cord self-locking female connector is correctly aligned to the corresponding male connector on
driver and push together until click-locked. To disconnect; turn female connector anti-clockwise to unlock and pull apart from driver
•
Connect mains power plug to switching gear/power supply.
•
Switch on mains power.
7. PRECAUTIONS WHEN USING THE LED FIXTURE
Always wait 20 – 30 minutes for the LED light bars to cool down.
WARNING!
WARNING!
Always ensure at least one light bar is connected to the fixture before switching
on. LED Fixture has an intelligent LED driver which will increase or decrease power to match
the amount of light bars connected to the system.
9. STORAGE AND DISPOSAL
Store the LED fixture in a dry and clean environment, with an ambient temperature of -25ºC to 55ºC.
The product must not be discarded as unsorted municipal waste but must be collected separately for the purpose of treatment,
recovery and environmentally sound disposal.
10. WARRANTY
PhotonTek warrants the mechanical and electronic components of their product to be free of defects in material and workman-
ship if used under normal operating conditions for a period of five (5) years from the original date of purchase. If the product
shows any defects within this period and that defect is not due to user error or improper use PhotonTek shall, at its discretion,
either replace or repair the product using suitable new or reconditioned products or parts. In case PhotonTek decides to replace
the entire product, this limited warranty shall apply to the replacement product for the remaining initial warranty period, i.e. five (5)
years from the date of purchase of the original product. For service; return the product to your shop with the original sales receipt.
8. INSPECTION, MAINTENANCE AND REPAIR
Make sure mains power is switched off.
WARNING!
Ensure the power supply cord is not coiled and does not touch any hot surfaces.
WARNING!
Connect the cabling according to local rules, safety regulations and electrical code.
WARNING!
Ensure power cord rating matches mains supply voltage.
WARNING!
Do not connect or disconnect the LED fixture under load.
WARNING!
WARNING!
If not using an external lighting controller ensure external switching gear can cope
with the inrush current of the LED fixture. Always use a timer contactor suitable for switching
a capacitive load. Never use household timers to switch the LED fixture!
Disconnect the LED fixture from mains before performing any maintenance or repairs.
WARNING!
WARNING!
Do not open or disassemble the LED fixture, it contains no serviceable parts inside.
Opening the LED fixture can be dangerous and will void the warranty.
Do not connect or disconnect the LED fixture under load
WARNING!
Always wait 20 – 30 minutes for the LED light bars to cool down.
WARNING!
Do not clean the LED fixture with detergents, abrasives or other aggressive substances.
CAUTION!