7
Modeling Light:
The modeling light has three modes of operation:
1.
MANUAL
adjustment [press the
MANUAL
button, LED on] adjusts the modeling
lamp intensity with the
MODEL
slide control knob. As with flash power, minimum
setting is full left and maximum setting is full right. The
MODEL
intensity scale
corresponds to the
FLASH
intensity scale, measured in f-stops.
2.
TRACK mode causes the modeling lamp intensity to track the
FLASH
control knob
setting. The modeling lamp may be set to full intensity at any
FLASH
control knob
position, by simply pressing the
TRACK/SET
button a second time, (you will notice
the TRACK/SET LED light blink once) with the
FLASH
control knob in the desired
position. Setting is retained when user returns from another mode.
3.
FULL ON/OFF
is exactly what it says. Press the
FULL ON/OFF
button to turn the
modeling lamp OFF (LED off) or ON (LED on).
All mode settings are retained, even after the power has been turned off.
PL1250 Accessories:
A
Digital Display
for the flash power setting is available as well as the large assortment
of PowerLight reflectors, umbrellas, softboxes, snoots, barndoors and cases. (See the
listing later in this manual)
PL1250DR and PL2500DR Accessories:
A
Remote Digital display/flash control
, a
Remote Digital Display & Infrared Receiver
and a hand-held
Infrared Controller
are available, as well as the large assortment of
PowerLight reflectors, umbrellas, soft boxes, snoots, barndoors and cases. (See the listing
later in this manual)
1
6
3
2
7
8
4
9
5
tm
