CURE M+
To unplug, first turn the power off by the mains and leave to discharge for 10-15 seconds. The plug and
power cord can then be disconnected. Do not operate if one of the following has occurred:
• The power cord or plug is damaged, cut or frayed.
• Liquid has been spilt in the machine. Or, the unit exposed to any source of water. (including rain)
• The machine has been dropped or the case had been damaged
• The machine does not operate normally after following the operating instructions
SAFETY GUIDELINES
• Keep the unit, platform and un-cured parts out of the reach of children.
• The unit should be operated on a stable and level surface, preferably away from direct ambient light.
• Do not look directly into the light if they are on (This should not be possible with the safety switch). If you
have them please wear light blocking goggles.
DISPOSAL INSTRUCTIONS
Do not throw any electronic device into typical house hold waste when discarding. To minimise pollution and
to help protect the environment, please recycle this unit or return to Photocentric.
Please note that the latest instructions can always be found on our website:
www.photocentricgroup.com/3d-support
SAFETY INFORMATION
Please read the instructions carefully. Keep this document for future reference. Follow all warnings/
instructions marked on the product.
• Cure M+ weighs 20 kg. Make sure you have 2 people to correctly remove the unit from the crate.
• The dimensions of Cure M+ are 390mm(H)x440mm(D)x440mm(W). Take care to choose a flat, stable
work space to accommodate the dimensions.
• Plug in the power cord first and then attach to the AC power outlet. Or, vice versa, unplug the power
cord before disconnecting from the printer.
• Do not operate outdoors without suitable protection
• Do not allow any resin to enter the chassis: clean spillages immediately.
• Disconnect the printer from AC outlet before storage or when not used for a long period of time or
inactive for long periods of time.
• This unit is connected to the electrical network with an input of 110-240V, 50/60 Hz.
• Do not allow anything to rest on the power cord. Do not locate this product where people could walk
on the cord or in a walk-through location.
• If an extension cord is used with this product, make sure that the total ampere rating of the equipment
plugged into the extension cord does not exceed the extension cord ampere rating. Also, make sure that
the total rating of all products plugged into the wall outlet does not exceed the fuse rating.
• Do not overload a power outlet, strip or receptacle by plugging in too many devices.
• Use the product only with the supplied power supply cord set.
• In case of malfunction, disconnect the printer immediately from the power network.
• Do not attempt to fix this product by yourself, as opening or removing covers may expose you to potentially
dangerous voltage points to other risks.
• Refer all repairs to qualified service personnel. Please send an email to your national supplier or contact
technical service at:
4
