To connect the product to your WIFI you have
to place the product next to a PC with a WIFI
connection. Click on the WIFI symbol located at
the top right of the display.
On the display you will see the connection procedure.
Click on start WIFI AP and from your PC access the
Wifi network called “PhocentricCUREMWIFI”.
To connect the product to your Wifi line you
have to place the product next to a PC with Wifi
connection. Click on the Wifi symbol located at
the top right of the display. When the connection is
established, open the browser and go to the link:
http://191.168.1.1/wifi
The lid should never be opened during the
execution of a program of polymerization. For this
reason there are pause and stop keys on each
screen. However the CURE M does have a system
of Automatic emergency shut-off connected to the
cover. In case of accidental opening of the cover
the LEDs will stop working and a screen will appear
alarm (see right).
If the LEDs do not switch off immediately remove
the power to the oven and contact technical
support. The CURE M also has a protection system
to prevent overheating: in case of an excessive
increase in temperature the oven will react by
blocking every activity, the LEDs will stop working
until the temperature drops to an acceptable level.
Wifi connection
Alarms
CURE M
CURE M
If the CURE M does not turn on, check that the
power cord is inserted correctly in the power
socket and in the plug in the rear panel.
Keep CURE M in a ventilated place away from
sources of heat, away from flammable materials
and liquids that may cause a safety risk. Keep the
Cure M at least 20cm away from the wall. Do not
obstruct in any way the pipes, their openings to
the outside and the fans on the rear panel and on
the bottom to avoid damaging the CURE M itself.
Keep CURE M in an environment with temperatures
of 18 °C to 28 ° C.
External dimensions:
355x410x550
Curing chamber dimensions:
200x200x200
Emitter type:
hi-power LED 5W
Number of emitters:
30
Irradiance system:
OmniRay 360 °Irradiance
Wavelengths:
2
Emission centralization:
λ1 365nm - λ2 405nm
Emission opening:
+/- 20nm
Total emitter power:
150W
Emission control:
16 bit PWM control Heating
System:
Eco-passive
Heating control:
6x PID controller
Management:
16bit IDM processor
Interface:
3.2’’ TFT
Programs :
2 standard - custom set n°7 memory
Command :
Auto off
Touch screen:
Yes
Connectivity:
2.4Ghz WiFi
Power supply:
Inside
Power supply voltage:
110/220 3A 50-60Hz
MAINTENANCE
ENVIRONMENTAL
OPERATING
CONDITIONS
TECHNICAL
FEATURES
DIMENSIONS
355 mm
410 mm
575 mm
318 mm
