![Phonocar VM015 Assembling Instructions Download Page 40](http://html1.mh-extra.com/html/phonocar/vm015/vm015_assembling-instructions_1553276040.webp)
40
Installation problems, causes and remedies
Player does not
Fuse is burnt.
Replace fuse with a new equivalent one.
switch on.
Screen is not switched on.
Switch screen on.
Water condensation.
Wait about 1 hour until Players is completely
dry.
Unstable working
Remote-control battery is flat.
Replace with new battery (Cr2025) and
condition.
check correct voltage
Sensor of player or Remote control dirty
Clean sensor/receiver.
No picture
Check selected video-source
Select internal or external video, in relation to
the
source.
Reproduction does
Disc wrongly inserted.
Check and insert disc with label upward.
not start.
Disc dirty
Clean disc.
Insert disc i not compatible with Player.
Check that the formats to be reproduced
are compatible with the player.
Watching is reserved to adults only.
Eliminate child-protection or change
protection-level.
Pictures is not
Fast Forward or Fast Backward are in course.
Under these circumstances, non perfect
clear or disturbed.
pictures are a normal thing.
Car-battery is extremely weak
Check battery and cables DVD-player
(nearly flat)
does not work correctly if tension
is lower than 10,8 Volt
The active screen-matrix may be exhausted.
Replace matrix or the whole screen.
essere
esausta.
Reproduction
Disc is scratched or damaged.
Replace disc.
is bympy
INVALID
No disc is inserted.
Insert a disc.
DISC FORMAT
Disc is very dirty.
Clean disc.
NO VALID
Remote-control unable to effect commands
This is no bad sign. Some discs simply do
not foreseen certain functions.
TV-system is
The inserted disc is a PAL or NTSC-type.
Change System in relation with
not correct.
the inserted disc.
PROBLEM CAUSE
REMEDY
If an operation gets blocked, the screen will turn black or the DVD-player will no longer run correctly.
If this happens, switch DVD-player off and on again.
If this does not help, repeatedly effect operation 1) and 2), one after the other, until the correct running is re-estab-
lished.
1) Turn the ignition key to switch DVD-player off and on again.
2) Press RESET on the front-panel.
This Trouble-shooting Table will help resolving problems concerning the DVD reproduction.
In any case, always check if the system has been correctly connected or ask a professional Installer for advice.
IN CASE OF DIFFICULTIES