Phonic PCR2213 Plus, User Manual

Page: 14 / 40

PCR2213 10
English
4.2 REAR PANEL
Just like the front panel, the text above the input/output sockets
are STEREO mode and the text below the sockets are MONO
mode. They are clearly marked to minimize mistakes.
19. IN 1 / IN 2
The input sockets are standard XLR female type. Set in the
signal to IN 1 in MONO mode. The IN 2 socket is not effective in
MONO mode.
20.
Φ
These are phase invert buttons, the phase will be inverted as soon
as the button is pressed.
21. LOW 1 / LOW 2
These are the LOW outputs. In MONO mode, they become LOW
and MID output.
22. HIGH 1 / HIGH 2
These are the HIGH outputs. In MONO mode, HIGH 1 is not in
used. HIGH 2 is the HIGH output.
23. Sub Output
This output will always output the summed output signal from
the low 1 and low 2 channels when in stereo mode or the low
frequency signal when in mono. The purpose of this output is to
provide additional low-end output to subwoofers.
24. SUB
Σ
When set this switch to the ON position, the subwoofer output
will be activated. It will be disengaged when users switch to the
OFF position.
25. STEREO/MONO
Slide to top for STEREO 2-way mode, and slide down for MONO
3-way mode.
26. POWER SW.
To turn the unit on and off. This switch is best located in the rear
panel to avoid accidental tampered during operation which en-
danger the whole speaker system.
27. POWER SOCKET
Standard IEC socket for power connection. Check the voltage
before connection.
28. GROUND POINT
Chassis grounding point for properly grounding.
28 27 26 25 1 21 20 22 23 24