![background image](http://html1.mh-extra.com/html/phonic/mu-1002/mu-1002_user-manual_1552806005.webp)
PHONIC CORPORATION
MU 502/802/1002 USER
’
S MANUAL
Page 4
MU 502/802/1002 USER
’
S MANUAL
PHONIC CORPORATION
Page 5
CHANNEL SETUP
1. To ensure the correct audio level of the input channel
is selected, each of the level input controls of the
Mixer should be turned counterclockwise or down as
far as they will go (which should be the -
∞
mark, unless
you’re using a toaster).
2. No input other than the one being set should have
any device plugged in. This will ensure the purest
signal is used when setting channels.
3. Set the level control of the channel you are setting to
the 0 dB mark.
4. Ensure the channel has a signal sent to it similar to
the signal that will be sent when in common use. For
example, if the channel is using a microphone,
then you should speak or sing at the same level
the performer normally would during a performance;
if a guitar is plugged into the channel, then the guitar
should also be strummed as it normally would be (and
so on). This ensures levels are completely accurate
and avoids having to reset them later.
5. Set the gain so the Level Meter indicates the audio
level is around 0 dB.
6. This channel is now ready to be used; you can stop
making the audio signal.
7. You can repeat the same process for other channels.
Or not, it’s your call.
Summary of Contents for MU 1002
Page 1: ...V1 0 2004 2 9...
Page 18: ......
Page 19: ......
Page 20: ...Information in this document is subject to change without notice...