4
MIC.1- 5:
Select this menu point to change the parameters for respectively
microphone and line-in 1-5. Microphone and line-in 3-5 are not
standard, but can be built in as an option.
VOLUME:
Used for adjusting the signal level immediately before mixing
point. As a starting point choose 0 dB. If the output signal is
distorted, this parameter should be reduced.
REMOTE:
REMOTE set to “ON” allows mute of line-in via the 25 pin
Sub-D port marked CONTROL on the back panel of the
amplifi
er.
MIX.OUT:
This menu point determines, whether a signal connected to an
input can be heard on the teleloop (LA) or not (NONE).
TAPE:
Select TAPE to change the parameters for TAPE INPUT.
VOLUME:
Used for adjusting the signal level immediately before mixing
point. As a starting point choose 0 dB. If the output signal is
distorted, this parameter should be reduced.
MIX.OUT:
This menu point determines, whether a signal connected to an
input can be heard on the teleloop (LA) or not (NONE).
REC.1 & 2:
Select this menu point to change the parameters for the wire
less receiver modules. The wireless TOA receiver modules are
not standard, but can be built into the amplifi er as an option.
VOLUME:
Used for adjusting the signal level immediately before mixing
point. As a starting point choose 0 dB. If the output signal is
distorted, this parameter should be reduced.
STARTUP:
Select “ON” and the wireless TOA receiver modules are turned
on,
when
the
amplifi er is turned on. Choose “OFF” and the
wireless microphones are switched off when the amplifi er is
turned
on.
REMOTE:
REMOTE set to “ON” allows the wireless TOA receiver
modules respectively switch on and off via the 25 pin Sub-D
port marked CONTROL on the back panel of the amplifi er.
MIX.OUT:
This menu point determines, whether a signal connected to an
input can be heard on the teleloop (LA) or not (NONE).
LogiBit 1200 manual
Menu Structure
