5
USEPHOENIX.COM
Toll-Free in USA 1-800-533-7533 or
1-608-237-8400
Light Bar = On
The light bar colors and animations will persist while in
Settings.
3.3.12 Dew Point
The screen displays the ambient dew point.
3.3.13 Shut Down Sequence
Press the Set button to adjust the shutdown time in one
minute increments ranging from 3 – 20 minutes.
The shutdown time allows the blower to run to remove water
from the coil and to allow the evaporator to acclimate to the
ambient conditions. At the end of the shutdown time the
unit will automatically purge to remove any remaining water.
The proper shutdown is dependent on conditions. Increasing
your shutdown time will help ensure there is no residual
water in the unit.
***IMPORTANT*** - Unplugging the unit without running
the shutdown sequence will allow water to remain in the unit
after use. If the unit is tilted more than 20 degrees on the
non-handle side, water may spill out of unit.
3.3.14 Language
The display will greet the user in order to help them identify
the language settings for the machine.
Press the Set button to browse available languages.
Press the Next button to confirm selection and advance to
the next screen.
Light Bar = On
The light bar colors and animations will persist while in
Settings.
3.3.15 About This Device
The following information is displayed on the About this
Device screen:
Device ID
Hardware Version
Firmware Version
Press the Next button to advance to the next screen.
Light Bar = On
The light bar colors and animations will persist while in
Settings.
3.3.16 Diagnostic Mode
Press the Next button for 3 seconds to enter Diagnostic
Mode. This action can also be performed at any time while
the machine is powered on.
If Alerts are active, press the Next button to advance to
the next screen. Else, press the Next button to return to the
Dashboard.
Light Bar = On
The light bar colors and animations will persist while in
Settings.
3.3.17 Diagnostic Mode - Pump
Press the Set button to toggle the Pump On/Off.
Press the Next button to advance to the next screen.
