Phoenix #98836 Motorized Treadmill
29
HOW TO MAINTAIN THE
#98836
TREADMILL
HOW TO MAINTAIN THE
#98836
TREADMILL:
Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance
could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY
coverage.
Important
: Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep
liquids away and keep it out of direct sunlight.
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
BELT ADJUSTMENT
:
Belt adjustment performs two functions: adjustment for tension and centering. The running belt has been adjusted properly
at the factory. However transportation, uneven flooring or other unpredicted reasons could cause the belt to shift off center
resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To adjust the belt back to
it’s
proper position please follow the directions below:
Walking belt has shifted to the left
:
First unplug the power cord from the surge protector. Using the
Allen Wrench
6mm (Part #A)
provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power
cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself,
moving back towards the center. Repeat the above procedure until the walking belt is centered. It may be
necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while
walking. Refer below to the "Walking belt slipping" instructions.
Walking belt has shifted to the right:
First unplug the power cord from the surge protector. Using the
Allen
Wrench 6mm (Part #A)
provided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug
the power cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to
correct itself, moving back towards the center. Repeat the above procedure until the walking belt is centered. It
may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is
slipping while walking. Refer below to the "Walking belt slipping" instructions.
Walking belt is slipping
:
First unplug the power cord from the surge protector. Using the
Allen Wrench 6mm (Part
#A)
provided, turn both the left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the
clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should
now walk on the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not
slipping. The tension should be just tight enough not to slip.
1.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Formatted:
Bullets and Numbering
Formatted:
Bullets and Numbering
Formatted:
Bullets and Numbering
Formatted:
Bullets and Numbering
Formatted:
Bullets and Numbering
Formatted:
Bullets and Numbering
