INSTRUCTION MANUAL
INSTALLING THE ELEVATOR PUSHRDD
1. Locate the pushrod exit slot on the right side
and left side of the fuselage. It is located
slightly ahead and below the horizontal
stabilizer.
2. Carefully cut away the covering material from
the slot.
3. Working from inside the fuselage, slide the
threaded end of the pushrod until it reaches the
exit slot. Carefully reach in with a small screw
driver and guide the pushrod out of the exit slot.
4. Install the clevis into the two elevator pushrod.
Make sure 6mm of thread shows inside the clevis.
5. The control horn should be mounted on the
bottom, left side and right side of the elevator at
the leading edge, in line with the elevator
pushrod.
6. Drill two holes through the elevator using the
control horn as a guide and screw the control
horn in place.
7. Attach clevis to the third hole in the control
horn.
8. Connect the two elevator pushrod using the
domino.
18
BERG FALKE
9. Locate one nylon servo arm, and using wire
cutters, remove all but one of the arms. Using a
2mm drill bit, enlarge the third hole out from the
center to accommodate the elevator pushrod
wire.
10. Plug the elevator servo into the receiver and
center the servo. Install the servo arm onto the
servo. The servo arm should be perpendicular
to the servo and point toward the middle of the
fuselage.
11. Be sure both elevator halves are flat. Center
both elevator halves and hold them in place
using a couple of pieces of masking tape.
12. With the elevator halves and elevator servo
centered, carefully place a mark on the elevator
pushrod wire where it crosses the hole in the
servo arm.
13. Using pliers, carefully make a 90 degree bend
up at the mark made. Cut off the excess wire,
leaving about 8mm beyond the bend.
14. Insert the 90 degree bend up through the hole
in the servo arm, install one nylon snap keeper
over the wire to secure it to the arm. Install the
servo arm retaining screw and remove the
masking tape the elevator halves.
2 x 1 6mm TP Screw
ouu11u111uum11,, --------- 4
Domino
�
- ------- 1
1 .7 x 1 00mm Push rod
---------------------- 1
1 . 7 x 1200mm Push rod
----------------------2
Plastic Control Horn
� --------------------2
� --------------------2
Kwik link (M2)
� ------ ------- 2
1 .6 x 8mm TP Screw
Qnmnmmm ------------ ---2
Snap keeper
p
--------- 1
11
Cut off excess.
ril
Cut off shaded portion
