Bestell-Nr. 99425 Ausgabe 11.2014 Version 1-0
7.
Error messages on the handswitch display
Code
Description
Remedy
HOT
Overheating has caused it to stop the
control unit
•
Wait until the control unit has cooled down
and HOT
is no longer displayed
00
Internal Error Channel 1
•
Unplug the power cord and contact your RK
contact person
01
Internal Error Channel 2
02
Internal Error Channel 3
12
Defect Channel 1
•
Unplug the control unit.
•
Fix the external short circuit or plug in the
correct motor to the motor socket that shows
the error.
•
Start the control unit again.
13
Defect Channel 2
14
Defect Channel 3
24
Overcurrent Motor M1
•
Remove jammed objects from the driving area.
•
Desk might be overloaded Remove load from
desk.
•
Contact your RK contact person
25
Overcurrent Motor M2
26
Overcurrent Motor M3
48
Overcurrent Motor Group 1
49
Overcurrent Motor Group 2
60
Collision protection
62
Overcurrent Control Unit
36
Plug detection in Motor socket M1
•
Plug in the correct motor to the motor socket
that shows the error.
•
Reset all motors.
37
Plug detection in Motor socket M2
38
Plug detection in Motor socket M3
61
Actuator changed
55
Synchronization lost motor group 1
•
Remove load from desktop.
•
Reset all motors.
•
If error occurs after reset again, contact your
RK contact person
56
Synchronization lost motor group 2
67
High voltage
•
Unplug the power cord and contact the
customer service
70
Motor configuration changed
•
See chapter 4
71
Anti-Pinch configuration changed
•
See the operation manual of the control unit
Compact-e-EU on the producers homepage:
http://www.logicdata.at/
81
Internal error
•
Make a manual reset
•
Unplug the power cord and plug it in again
after a few seconds.
•
If this error occurs frequently, unplug the
power cord and contact your RK contact
person.
93
Connection error in the cascaded
network
(The error appears on the display for
15 seconds and then the control unit
goes into reset mode with the display
flashing
000
)
•
Check all the cable connections and try to reset
the motors.
•
If you cannot reset the motors, disconnect all
the control units from the power supply. Wait
for at least 5 seconds and then reconnect all
the control units to the power supply. Try to
reset the motors again.
•
If you still cannot reset the motors, please
contact your RK contact person
You can find the original operation manual of the control unit Compact-e-EU on the producers homepage:
http://www.logicdata.at/
