General
Information
MC11 Control Unit
6
66650 6.0
1. General Information
1.1
Configurations
The MC11 control unit is available in different versions: with and without the designation CARE or
HOSP. The "Possible Combinations" Chapter describes the different device combinations that are
available.
1.2
About these installation instructions
In order to install the MC11 control unit successfully and safely in the end product, these installation
instructions must be observed. These instructions are not an operating manual for the end product.
These instructions will help you to minimize danger, repair costs and down times. They will also
help you to maximize the reliability and lifespan of the end product.
CAUTION
The notices in these instructions must be followed! Following the guidelines during in-
stallation and connection procedures will help to minimize:
•
the risk of accident and injury, and
•
damage to the MC11 control unit or the end product.
These installation instructions have been written with due care and attention. However, we cannot
guarantee that the data, images and drawings are complete and correct nor do we accept any liabi-
lity for the information contained therein, unless required by law.
We reserve the right to make unannounced technical changes in the course of our continual
product improvement process!
1.3
Conventions used
Notices which do not relate to safety are indicated in these instructions with a symbol:
Triangular notice symbol
Explanations of warning notices
WARNING
WARNING indicates a hazardous situation which, if not avoided, could result in death
or serious injury.
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or
moderate injury.
NOTICE
NOTICE is used to address practices which are not related to personal injury but may
result in damage to the product or surroundings.
