CONTROL UNIT HE200
Installation
82687(-)
15
6.2.2
Electrical connection
CAUTION
Electric shock
Electrical components should be connected or disconnected only when the power supply cord is
unplugged.
There is a delay after the supply voltage is applied before the device actually turns on. Wait at
least 7 seconds before initial commissioning.
Routing the electrical cables
When routing the cables, be sure that:
•
the cables cannot get jammed,
•
no mechanical load (such as pulling, pushing or bending) will be put on the cables, and
•
the cables cannot be damaged in any way.
Fasten all cables (especially the connecting cables) to the end product using sufficient kink preven-
tion methods. Be sure that the design of the end product prevents the connecting cables from com-
ing into contact with the floor during transport.
Connecting the massage motors, the additional drives and the optional accessories
Make sure that you disconnect the components from all power sources before connecting them to
the CONTROL UNIT HE200 (refer to Figure 2 for the proper connection for each component).
CAUTION
Electric shock
You should only connect and disconnect the cables when they are completely disconnected from
any live current!
Summary of Contents for Dewert Okin HE200
Page 2: ......
