CONTROL UNIT HE200
Installation
82687(-)
13
6. Installation
6.1
Safety notices to observe during installation
Basic safety rules must be followed in order to ensure that the end product can be continually op-
erated in a safe manner. These rules must be observed while using the end product and while in-
stalling the CONTROL UNIT HE200 in the end product.
6.1.1
Ensuring operational reliability during installation
The safety and reliability of the end product containing DewertOkin components can be ensured by
using the proper construction methods as described below.
6.2
Installation procedure
Before installing and connecting the CONTROL UNIT HE200, make sure that you are observing all
of the safety notices found in the "Safety notices to observe during installation" section.
6.2.1
Mounting the CONTROL UNIT HE200 to the end product
Two screws should be used at the two mounting points to attach the CONTROL UNIT HE200 to
the end product.
The drilling dimensions shown in Figure 5 only illustrate an example and are not necessarily au-
thoritative for all applications.
Figure 5
Drilling dimensions (example): Mounting points on the CONTROL UNIT HE200,
(in mm)
Ø 7
158
Summary of Contents for Dewert Okin HE200
Page 2: ......
