Information about creating your Operating Manual
CU165
20
92290 1.0
Emergency shut off of a connected drive or the CU165
In an emergency, disconnect the power supply unit's power plug in order to shut off the connected
drive. The power plug to the power supply must always be accessible during operations so that it is
possible to shut down the drive or CU165 at any time.
Avoiding cable damage
Be sure that your operating instructions inform the user about the possible cable risks.
CAUTION
Risk of accident
The cables (particularly the connecting cable) should not be run over. In order to prevent injuries
or damage to the drive and CU165, no mechanical strain should be placed on the cables.
7.2
Programming (teach-in) for the RF hand-held remote control and app
(Blue-
tooth
®
)
The hand-held remote and app can be paired automatically (see chapter 7.2.1, page 20) or manu-
ally (see chapter 7.2.2, page 21).
To start using the RF hand-held remote control or
Bluetooth
®
device, the remote link with the
CU165 must first be established.
Requirement:
To operate your system with a
Bluetooth
®
device (e.g.: smartphone/tablet), down-
load the "OKIN" app from the appropriate platform and install it on your device.
Refer to the corresponding quick start guide to learn how to teach-in (program) your RF hand-
held remote control.
7.2.1
Automatic configuration
1
Connect the CU165 to the power supply.
2
The CU165 remains in pairing mode for 120 seconds. The pairing mode is split as follows:
•
An RF hand-held remote can be paired in the first 60 seconds.
•
A
Bluetooth
®
device can be paired in the second 60 seconds.
3
The pairing LED on the CU165 lights up during the teach-in phase of the RF hand-held remote.
4 RF-TOUCH hand-held remote (example):
Press and hold the
button
in the battery compart-
ment until the pairing LED flashes. The pairing phase is now finished. (Refer to the correspond-
ing quick start guide to learn how to teach-in (program) another RF hand-held remote control.)
5
After the teach-in process for the RF hand-held remote is finished, the pairing LED for pairing
the
Bluetooth
®
device starts to flash.
