CU165
Information about creating your Operating Manual
92290 1.0
21
6
The pairing LED switches off when the
Bluetooth
®
pairing process has timed out or when the
device has connected successfully.
•
If, during the RF remote's teach-in process, you press any button on an already paired hand-
held remote, it switches to the Bluetooth
®
teach-in mode.
7
If the RF remote or a
Bluetooth
®
device is discovered during the pairing phase, then pairing
mode is automatically ended. The pairing LED is switched off.
If automatic configuration must be repeated:
•
Remove the plug from the power supply and wait 60 seconds.
•
Then insert the plug back into the power supply. You can then start the new pairing process.
NOTICE
Only start
one
system at a time. Never configure multiple systems simultaneously.
7.2.2
Manual configuration
Requirement:
The system is already connected to the power supply.
1
Press the pairing button on the CU165 twice in quick succession (refer to page 11, Figure 2,
and item
C
). The pairing LED lights up.
2
The CU165 remains in pairing mode for 120 seconds. The pairing mode is split as follows:
•
An RF hand-held remote can be paired in the first 60 seconds.
•
A
Bluetooth
®
device can be paired in the second 60 seconds.
3
The pairing LED on the CU165 lights up during the pairing (teach-in) phase of the RF hand-held
remote.
4 Example RF-TOUCH hand-held remote:
Press and hold the
button
in the battery compart-
ment until the pairing LED flashes. The pairing phase is now finished. (Refer to the correspond-
ing quick start guide to learn how to teach-in (program) another RF hand-held remote control.)
5
After the teach-in process for the RF hand-held remote is finished, the pairing LED for pairing
the
Bluetooth
®
device starts to flash.
6
The pairing LED switches off when the
Bluetooth
®
pairing process has timed out or when the
device has connected successfully.
•
If, during the RF remote's teach-in process, you press any button on an already paired hand-
held remote, it switches to the Bluetooth
®
teach-in mode.
7
If the RF remote or a
Bluetooth
®
device is discovered during the pairing phase, then pairing
mode is automatically ended. The pairing LED is switched off.
NOTICE
Only start
one
system at a time. Never configure multiple systems simultaneously.
