Phoenix Contact FL FXT, Quick Start Manual, Page: 10 / 18

FL SWITCH GHS
1-2
PHOENIX CONTACT 8042_en_00
1.2 Mounting of the extension module
Mounting:
1. Place the module onto the DIN rail from above (A). The upper holding keyway must be
hooked onto the top edge of the rail. Push the module from the front towards the
mounting surface (B). Check that the positive latches have snapped on properly.
Figure 1-2 Mounting extension modules
2. Now that the extension module is snapped onto the DIN rail, push it along the DIN rail
towards the head station (A), until the male connector/female connector of the modules
are interlatched and the sides of the modules lie flush with one another. Secure the
connection using the two screws (B).
Figure 1-3 Mounting extension modules
NOTE: Always switch off the supply voltage when mounting/removing the extension
module.
B
A
MAC
Address
Ord.No. 29 89 200
X29
MEM
FL SWITCH GHS 12G/8
X6
X5
X8
X7
X10
X9
X12
X11
X1 X3
X2 X4
X30 X31 US1 UI GND GNDI GND DI2
MODE
LNK
X 1 5 9 2 6 10 3 7 11 4 8 12
GNDI R2 R4 V.24
RESET
DI1
US1
US2
FAIL
DI2 UI
US2 DI1 UI R1 R3 X32
A
B
B
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx