Key Switch:
The Key switch determines which input the gate will use for it's
control signal. If the Key switch is up the gate circuit uses the signal on the input
as it's trigger source. If the Key switch is down the gate circuit will use an input applied to
the Bantam TT jack on the front panel (EXT) as it's trigger source.
Rel Rotary:
Release
time from 0.1 seconds to 2 seconds. This controls the period of time
between when the signal falls below the gate threshold and the gate releasing the signal.
Gate Switch:
Switching the gate switch down activates the gate circuit. This illuminates
the 20 (Red) LED to show the gate is active.
EXT:
This connector is a TT Bantam connector (6.35mm) An external trigger source can
be sent to this connector (such as a snare input), and if the
Key
switch is down the gate
circuit will be triggered by this.
Gain:
Rotary control. This controls the
make-up gain
of the module. As compression
often attenuates the signal, make-up gain is needed to bring the signal level back up
again.
Summary of Contents for N90-DRC 500
Page 5: ......
