Dear Customer,
Congratulations on buying your Phocos product! Please read the instructions carefully and thoroughly before using the
product. Your new CMLmppt controller is a “state-of-the-art” device which was developed in accordance with the latest
available technical standards. It comes with a number of outstanding features, such as:
Maximum Power Point Tracking technology, which increases the efficiency of your PV system
Clear, readable display of the state of charge
New housing design
Acoustic signal when the state of charge changes
Low voltage disconnect regulated by state of charge or voltage
USB connector for mobile phone charging or small music players/devices
Max. 16 mm
2
connector binding posts (10 mm² stranded wire with cable end sleeves)
Complete electronic protection
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important installation, set up, and safety operating instructions.
Please read the instructions and warnings in this manual carefully before beginning any installation.
Please do not disassemble or attempt to repair Phocos products. Phocos charge controllers do not contain user serviceable
parts.
Please observe all instructions with regards to external fuses/breakers as indicated.
The information contained in this manual must be observed in its full extent. The manual contains information regarding
installation, set up, and operation.
Please read this manual carefully before using the product, and pay special attention to the safety recommendations in it.
Maintenance and installation notes
When installing or working on the PV system, please disconnect the PV (solar) modules from the charge controller first, to
prevent any damages to the charge controller!
Please verify that all cable/wire connections are done properly and well insulated and that no water or humidity can ingress
in order to avoid any bad or loose connections that would result in excessive heating or further damage.
Please install a fuse or breaker near the battery before installing or adjusting the controller!
High voltage risks
Never touch any electrical conductors to avoid electrical shock.
Never work on live (energized) electrical equipment.
When working around a battery, do not allow tools to bridge the battery terminals, or short circuit any part of the battery.
13
All manuals and user guides at all-guides.com
