20
Important Note (Reset Code)
In order to avoid the interference from the other wireless
fish finder or the receiver (main unit) doesn’t receive
transmitter (transducer) signal, you can reset the code
between the receiver and transmitter by yourself according
to steps as below:
1. Receiver: please make sure the receiver must be under
power off, press the Zoom key ( ) at first , then press
the power key ( ), at the same time; and then the
display become black right away (Black mesh in the middle
area of the display), then you can continue to do following
step:
2. Transmitter: then check
the transmitter, you will
see a green button on the
transmitter (see the right
picture) keep pressing the green button, then connect the
power supply to the transmitter, after this, the receiver will
be power off automatically, in this condition, you can
release your hand from the green button and disconnect
power supply from the transmitter.
The product can use normally when you restart the machine
after doing these as above.
If the display of the receiver still in the balck (Black mesh
in the middle area of the display), it means you failed to
reset code, then you need to redo it according to the steps
as above. The channel number will increase one by one
after you successed to reset code each time.
