Philips WI121 series, User Manual

Page: 24 / 40

WI11
9.1.0 POWER SUPPLy
There are two sources of power for ProScribe operation: the battery and the AC adapter.
9.1.1 AC
You may operate your ProScribe with AC power in two different ways. Mounted in the Docking station
WD121 .., or
connected directly to the AC adapter (fig. 24a). To run your ProScribe on the base station, connect the AC adapter to the
jack at the rear of the base station and place the pad into. To plug the product directly to the AC adapter, locate and plug
into the DC adapter at the lower right corner of the product.
(fig. 24a)
CAUTION:
The ProScribe should not be docked if both devices (ProScribe and Docking Station) are powered through the AC adapter.
Also, it is not advisable to dock the ProScribe if the Docking Station is not powered through the AC adapter.
9.1.2 BATTERy
When using the ProScribe for the first time, it is advisable to charge the battery for at least 2 hours.
After the initial charging, when not in use, the ProScribe takes approximately three hours to fully charged; it takes 4 hours
to fully charged while in use. Battery duration depends on the actual use of the device and may be affected by heavy-duty
application.
In most applications it is between two and three hours.
The power light on the top right indicates the level of battery charge.
Turn on the power to see the power light.
●
Full charge
The power light is solid green.
●
Low charge
The power light is blinking green when the battery’s remaining charged falls to less than 6 percent.
●
Critical low charge
The power light blinks amber when the charge falls under 3 percent.
If your ProScribe is powered up and immediately enters the suspend mode, it means the battery is uncharged.
In order to optimize battery operation, open only the applications you are actually using.
To conserve battery power, disable WLAN when it’s not in use.
To change battery
● Switch OFF your ProScribe.
● Unlock I the battery latch 1 (ref. fig. 11b)
● While one hand holds the battery latch two in the unlocked position, use the other hand to pull the battery out of the slot.
● Replace with another battery
NOTE:
When fully charged and not in use, your ProScribe has a life of one week.
CAUTION:
Switch OFF your ProScribe before removing or changing the battery pack.