Philips SRP4004, User Manual

Page: 6 / 28

6 EN
CBL/SAT Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Definition Television
decoder (HDTV) and Tivo
VCR Video cassette player /
recorder, Personal video
recorder (PVR), VCR part
of TV/VCR, TV/VCR/DVD
and VCR/DVD combos
Example: setting up the universal remote
control to operate your TV:
1
Switch ON
the TV manually or use the
original remote control for this. Tune to
channel 1.
2
Pressandhold the
device selection
key
for5seconds
until the red Setup
light remains lit.
• The remote
control is now in setup mode.
3
Look up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit keys
to enter the code
for your brand
(e.g. Philips,
).
• If the red Setup
light turns off, an invalid code was
entered. In this case, try again.
4
Aim the remote
control at the TV.
Pressandhold
the
key. Release it
immediately
release
it as soon the TV
switches off.
• This step normally takes between
5 and 60 seconds. In extreme
circumstances this step can take up to
15 minutes.
5
Switch ON
the TV.
Try out the keys
you need for
operating it. Try, for
example, if the
- CH + and digit
keys function properly.
• If a key does not work as expected,
press
andhold
that key. Release it
immediately
as
soon as it works. For more information, see
chapter 2.3.2 .
6
Press the device
selection key twice
to finish setup.
• When no key
is pressed for
5 minutes or
more, the remote control will exit setup
mode, automatically saving all your
settings.
Important
If you made a mistake:
• Press the device selection key
twice
to exit
setup. The red Setup light turns off.
• Restart from the beginning.
• Ifthedevicedoesnotrespondatallornotto
allofthekeycommandsorifyoucannotfind
thecodeforyourbrand,enter‘9,9,9,9’instep
3andcontinuewithstep4.Theremotecontrol
willnowsearchitsfulldatabaseforacode
thatworkswithyourTV.Fulldatabasesearch
maytakeupto15minutes.
2.3.1 Setting up the remote control for
other devices
(DVD player/recorder,
Cable/Satellite box and VCR)
1
Make sure the device is turned on, fully
operational and able to respond to remote
control commands. E.g. insert a disc in the
DVD player / recorder or a video cassette in
the VCR.
2
Then follow steps
2
to
6
of ‘Setting up the
remote control for your TV’. Make sure to
use the correct device selection key: ,
or .
5 sec.
5 - 60 sec.
5-60 SEC.
SRP4004_27__Manual_80_210.indd 6 25-09-09 13:19