6
EN
7
EN
After initial setup
1
Make sure the TV is switched on.
2
Keep buttons and
pressed simultaneously for
5 seconds
.
• The green Setup light
lights up. The remote
control is now in setup
mode.
3
Press and hold
the button that does not function and
immediately
release it when the TV responds.
• If the button still does not function as expected, try
pressing it again for a longer period of time.
4
Keep buttons and
pressed simultaneously for 5
seconds
to save your settings
and exit setup mode.
•
When no button is
pressed for 5 minutes
or more, the remote control will exit setup mode,
automatically saving all your settings.
3 Using the universal remote
control
3.1 Buttons and functions
The illustration on page 2 gives an overview of all buttons
on the remote control. Try out the buttons that you need
for operating your TV.
Notes
•
Buttons having the same functions as the buttons
on your original remote control may have different
namings on the SRP1101.
•
Only functions that are available on your original
remote control can be used for operating your TV
with the SRP1101.
1
................................... setup light. Lights up when a remote
control command is being sent and
when the remote control is in setup
mode.
................................. switches the TV on/off.
Note
For some TV brands/types, the button will only switch
off the TV. You will have to press a digit button (direct
channel selection) to switch on the TV again.
2
....................... teletext on ( )/off (
).
................................. selects between regular (4:3) and
wide screen (16:9) TV.
................................ mutes TV sound.
3
................... previous/next channel.
................... adjust TV volume.
4
.............. digit buttons for direct channel/track
selection.
5
................................. switches between external (Audio/
Video) inputs of your TV.
6
................................. selects between one and two-figure
channel numbers and channel
numbers with more than two or
three figures.
3.2 Resetting a button to its original function
If an improved button (see chapter
2.2.1
) still does not
function as expected, you can always reset the button to its
original function.
1
Keep buttons and
pressed simultaneously for 5
seconds
, until the green
Setup light lights up.
• The remote control is
now in setup mode.
2
Press digit buttons ,
and , in that order.
• After each button press
the green Setup light
blinks once.
Using
the
univ
ersal
remote
contr
ol
English
5 sec.
5 sec.
5 sec.
