sPDS-60ca Product
Guide
6
Mount the sPDS-60ca
Make sure the sPDS-60ca device is powered OFF before mounting and connecting. A
power screwdriver is recommended.
1. Position the sPDS-60ca device in its designated mounting location. Make sure the
mounting location is
fl
at, suitable for the mounting hardware, and clear of debris
and other obstructions.
2. Using four M3.5 or #6 screws suitable for the mounting surface, secure the
sPDS-60ca device to the surface using the two mounting slots located at both
ends of the device.
Install EMI Suppression Cores
The sPDS-60ca ships with three EMI suppression cores.
These suppression cores
reduce electromagnetic noise that can interfere with other electrical equipment.
The white suppression cores are for Flex strands or
fi
xture leader cables. The black
suppression core is for the IEC power cable.
Before attaching the cores, make sure that each set of ferrite metal halves are secure
in their plastic housing.
1. Attach the black suppression core to the power cable:
• Near the end of the cable that connects to the power / data supply, coil the
IEC power cable into a small loop.
• Place the section of the loop where the cord is doubled into the suppression
core. Be sure the cord is securely in the core’s middle.
• Snap the core shut around the doubled cord.
2. Attach a white suppression core to the
fi
xture strand or leader cable attached
to port 1.
• Near the connection to the power / data supply, coil the strand or cable into
a small loop.
• Place the section of the loop where the cord is doubled into the suppression
core. Be sure the cord is securely in the core’s middle.
• Snap the core shut.
3. Repeat step 2 for the second white suppression core, if necessary.
E
Make sure that there is adequate
space to make all connections to the front
and rear of the device. Also, the vents at
the top and rear of the device should not
be obstructed.
E
Make sure that the device is securely
attached to the mounting surface and free
of excessive vibration.
8.8 in
(224 mm)
8.3 in
(211 mm)
2.3 in
(58 mm)
4.0 in
(102 mm)
DMX IN
ENET IN
OUT 2
AL
T
DA
TA
DMX OUT
