English
1 What’s in the box (Fig. A)
1) Headphones
2) Transmitter
3) AC/DC adaptor
4) Antenna tube
5) 2 x AAA rechargeable shortened sleeve NiMH
batteries (SBC HB550L)
2 Get started
Note
•
Before using the headphones for the first time, charge the
supplied batteries for at least 10 hours.
•
Only use Philips rechargeable shortened sleeve NiMH
batteries with your headphones. Other types of
rechargeable batteries cannot be charged with this system.
•
AAA alkaline batteries can be used to operate the
headphones, but cannot be charged with this system.
•
If the volume of the audio source is insufficient, the
transmitter automatically turns off.
1
Install/Replace supplied batteries (Fig. B).
2
Install the antenna tube into the transmitter (Fig. C).
3
Power on the transmitter (Fig. D).
»
Red LED is on when audio source is connected.
»
Red LED blinks if no audio source is connected for
two minutes.
»
Red LED is off if no audio source is connected for four
minutes.
4
To charge the headphones, connect the charging cable
with the headphones (Fig. E).
»
Headphones: red LED is off during charge.
»
Transmitter: green LED is on during charge and is off
when headphones are fully charged.
5
Power on the headphones and red LED is on (Fig. F).
6
Connect the audio device with the transmitter (Fig. G).
»
Red LED is on when audio source is connected.
Tip
If there is interference, tune the transmitter and the headphones
to the same channel (Fig. H).
3 Product version table
Version / Region
/10 Europe /05 UK
Input voltage / frequency
100-240V / 50/60Hz
Output voltage
8V 200mA
Carrier / Reception
frequency
Channel 1
863.5MHz
Channel 2
864.5MHz
Transmission power
<8 dBm
For further product support, please visit
www.philips.com/support
