Philips Senseo HD7855, User Manual

Page: 7 / 52

7
5 Brewing black
SENSEO
®
coffee
1
Make sure that the water reservoir is filled
with fresh cold tap water (Fig. 3).
E
Tip:
Use fresh water every day.
2
Put the plug in an earthed wall socket.
3
Press the on/off button. The on/off button
flashes slowly while the water heats up. (Fig. 8)
D
Note:
If the on/off button flashes rapidly, the water
reservoir does not contain enough water for
brewing one cup of coffee.
4
Pull the lid lever upwards to open the
lid. (Fig. 12)
5
If you want to make one cup of SENSEO
®
coffee, place the 1-cup pod holder
q
in
the machine (1). If you want to make two
cups, put the 2-cup pod holder
qq
in the
machine (2). Make sure the pod holder is
clean. (Fig. 13)
6
Place 1 coffee pod in the 1-cup pod holder
q
(1) or place 2 coffee pods in the 2-cup pod
holder
qq
(2). Place the pod or pods properly
in the centre of the pod holder, with the
convex side pointing downwards. Press the pod
or pods lightly into the pod holder. (Fig. 14)
D
Note:
Make sure the coffee in the pod or pods is
evenly distributed.
C
Caution:
Never put normal ground coffee or use torn
pods in the SENSEO
®
machine, as this causes
it to become blocked.
7
Close the lid and lock the lever. (Fig. 15)
B
Warning:
Make sure the lid is closed properly and the
lid lever is locked before you start brewing
coffee.
4 Flushing the
machine before first
use
It is important that you flush your SENSEO
®
coffee
machine before first use. After the flushing cycle,
the machine is ready for brewing SENSEO
®
coffee.
C
Caution:
Never interrupt the flushing cycle halfway. If you
do, the boiler does not fill itself properly.
1
Tilt the water reservoir backwards (1) and lift
the water reservoir off the machine (2) (Fig. 2).
2
Fill the water reservoir. (Fig. 3)
3
Tilt the water reservoir and place the bottom
back onto the machine (1). Then press the top
of the water reservoir towards the machine
(2) (Fig. 4).
4
Slide the milk spout onto the machine. Make
sure you attach the milk spout by sliding it
over the guiding rails on the coffee spout. You
hear a click sound when the spout is attached
properly (Fig. 5).
5
Place a bowl with a capacity of at least 1 litre
under the coffee spout. (Fig. 6)
6
Make sure a pod holder, without pod or pods,
is in place. (Fig. 7)
7
Put the plug in an earthed wall socket.
8
Press the on/off button. The button lights
up to indicate that you have to flush the
machine. (Fig. 8)
9
To start flushing, press any of the recipe
buttons. (Fig. 9)
• During the flushing cycle, the boiler fills itself
with water from the water reservoir and cold
water comes out of the coffee spout. During the
flushing cycle, the machine produces more noise
than during a regular brewing cycle (Fig. 10).
• When all the water in the water reservoir
has been used up, the flushing cycle is
finished and the machine switches off. You
may notice some steam coming from the
machine, this is normal (Fig. 11).
10
Fill the water reservoir with fresh tap water
and place it back onto the machine.
ENGLISH