Infrared Remote Control Overview
29
PL1 LED Luminaires
Installation & User’s Manual
INFRARED REMOTE CONTROL
1. Infrared Remote Control Overview
The PL1IRR infrared preset programming remote (sold separately) allows users convenient access to adjust and
program luminaire parameters - presets (1 through 6 and Off), intensity, preset color temperatures, or full color
mixing from the floor. Before using the remote, please familiarize yourself with all available controls shown in
Figure 3
.
Infrared Remote Control Features
Figure 3: PL1IRR Programming Remote
LEARN
EXIT
1
LASER
COLOR
PRESETS
ENTER
PROGRAM
CANCEL
RED
GREEN
BLUE
WHITE
S
S
S
S
T
T
T
T
WHITE
2
3
4
5
6
OFF
WARM
COOL
DAY
INTENSITY
PL1IRR
Intensity Raise/Lower
-
Press top button to raise intensity and
bottom button to lower it. Tap the up
for 2% increase or tap down for a 1%
decrease. Press and hold (top or
bottom button) for sequential raise/
lower.
Preset (White Color Temperature)
-
Allows selection of Warm, Cool or Day
color temperatures.
Note, only intensities may be stored
on White Color Temperature presets.
These presets cannot be edited or
changed
Presets (6 Levels or Off)
-
Allows selection and programming of
one of six Presets (1 through 6) or
Preset Off.
Notes:
•
Preset Off cannot be edited or
changed.
•
Presets 1 through 6 on remote con-
trol (equate to) Presets 5 through 10
on PL1 LED luminaire display.
Individual LED Color Adjustment
-
Allows the raising or lowering of
individual LED colors. Press top
button to change color and bottom
button to lower it. Tap the up for 2%
increase or tap down for a 1%
decrease. Press and hold (top or
bottom button) for sequential raise/
lower.
Program -
Enter
- After the luminaire to be
programmed is selected (by Laser),
press Enter to set the luminaire to
programming mode.
Laser (Luminaire Selector)
- Press
Laser to select individual luminaire for
programming / adjustment.
Exit
- Press to exit programming mode.
PL1IRR LED (indicator)
-
The LED indicator will flash each time
a button is pressed.
WARNING!
THIS DEVICE IS A CLASS 2 LASER. DO NOT STARE OR LOOK
DIRECTLY INTO BEAM.
Cancel
-
Cancels the learn features (any
programming made will not be
recorded) RGBW will not be changed.
Learn
-
After adjustments are made, the Learn
button (in conjunction with a preset
button) stores the new settings to a
specific preset if desired.
Laser / IR Window
-
Laser and IR programming emits from
this end.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LASER DIODE
WAVELENGTH: 630 - 680 nm
MAX OUTPUT: <5 mW
