Philips SCD589, User Manual

Page: 24 / 76

Default factory settings
Parent unit
– Loudspeaker volume: 1
– Microphone sensitivity: 3
– Sound alert: on
– Temperature alert: on
Baby unit
– Loudspeaker volume: 3
– Nightlight: off
– Lullaby: 1
– Temperature alert low: 58°F
– Temperature alert high: 87°F
Compliance information
The FCC ID number is located on the cabinet bottom of Parent Unit and in battery
compartment of Baby Unit.
The term ‘IC:’ before the certification number signifies that Industry Canada technical
specifications were met.This certification means that the equipment meets certain radio
communications and operational requirements.
This device complies with Part 15 of the FCC Rules and ICES-003 of Industry Canada. Operation
is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.This device complies also with RSS-213 of Industry Canada.
Radio Interference
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and applicable Industry Canada specifications.These limits
are designed to provide reasonable protection against harmful interference in a residential
installation.This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
24
EN
Important information