19
18
Mode
TV
VCR/DVD
CBL
S
A
T
AUDIO
Equipment
T
elevision
VCR
Cable
Satellite
C
D
Projector
LD
DBS
Amplifier
DVD
STB
T
uner
PVR
DTV
T
ape
W
eb TV
A/V
Recr
.
MD
of the 6 VCR/DVD keys when in any other mode.
VCR Record
In VCR Mode (including punch-through), the Record button has to be pressed
twice before the command is sent. This is also true if a VCR type is
programmed under any other Mode. The exceptions are for
DVD and SA
T codes where the Record button transmits the
command after only a single press of the Record button. In
any CD/Audio Mode, the Record button must also be
pressed twice.
LCD Panel and Backlight On-T
ime
The LCD Panel and Backlighting remain on for a user-
selectable time period (10, 20, 30,……90 seconds). The
power-on default is 10 seconds from the last button press.
T
o
change the LCD/Backlight On-time:
1.
Press and hold the Code Search button until the LED
remains on (after approximately 2-3 seconds) and the Main Setup Screen is
shown.
2.
Release the Code Search button.
3.
Press the Code Search button again, and release.
4.
Press and release a digit key 1-9
(1=10 seconds, 2=20 seconds, etc.). The LED blinks.
5.
Press and release
ENTER
(or Mute on the rubber
keypad) to save the setting.
The display shows the Main Setup Screen.
6.
Press
QUIT
.
LCD/Backlight On-time setting is now complete.
Button Pr
ess Acknowledge Beep Featur
e
SET
U
P
KE
Y
?
6
4
2
5
1
8
3
79
SET
U
P
KE
Y?
6
4
2
5
1
8
3
79
EN
TE
R
0
Ad
v
anced Options/Features
Ad
v
anced Options/Features
INPUT LCD Key
The
INPUT
button performs the TV/VCR antenna switch function when in
VCR Mode.
The
INPUT
button performs the A.B switch function when in Cable Mode.
The
INPUT
button performs the TV/SA
T switch function when in SA
T Mode.
The
INPUT
button performs the Input source switch function when in TV
Mode.
The
INPUT
button performs nonspecific functions when in CD/Audio Mode.
TV/VCR and TV/DVD Combo units
Note that for some TV/VCR and TV/DVD combo units you might need to set
up two dif
ferent buttons to control both parts of the combo unit. E.G., (refer-
ring to the Direct Code Entry section on page 10) you might need to set up a
code under the TV button to control the TV part of the combo unit AND a
separate code for the VCR or DVD under any other button you choose.
When any button is pressed, an audible beep is heard to acknowledge the
button press. This beep can be toggled on or of
f. The default state is enabled
(ON). T
o
change this:
1.
Press and hold the Code Search button until the LED remains on (after
approximately 2-3 seconds) and the Main Setup Screen is shown.
2.
Release the Code Search button.
3.
Press and hold MUTE until the LED blinks.
4.
Press
QUIT
.
The Beep Feature is now toggled OFF and Main Setup Screen is shown.
Repeat above steps to toggle back ON.
Mode Assignments
Code types are assigned as follows:
PM8TSMD.p65
12/9/02, 4:53 PM
18-19