Installation & User’s Manual
PLPROFILE4 MKII LED Luminaires
2 2
OPERATION AND PROGRAMMING
Table 2: Settings Menu User-Settable Parameters
Note:
To Exit the Settings screen, use the [ESC] key. [ESC] and [OK] can be used to cancel or save changes to an
individual parameter. However, once a parameter has been accepted, by pressing [OK] that change cannot be undone/
canceled by pressing the [ESC] key.
Parameter
Values
Default
Description
General
Fan
Full, Medium, or Quiet
Mode
Quiet Mode
Sets the luminaire’s output mode - Full
Mode, Medium Mode, or Quiet Mode.
Power-Up
All presets
Warm White
Users can set what the default preset is
when the unit is powered up. Factory
default is Warm White.
Red Correct
No
(off)
/ Yes
(on)
No
Red Correct (Correction) is internal
processing by the fixture that
compensates for the output variations that
occur in all red LEDs due to changes in
temperature. This compensation is
important if the colors of a fixture in a hot
environment needs to appear similar to
the colors of a fixture in a cooler
environment. With red correction on, there
will be a perceptible difference in output
vs. red correction off.
Power Save
Enable / Disable
Enable
Power Save sets fixture in a low-power
sleep mode.
Reset Hours
No, Yes
No
Resets luminaire’s operational hours.
Set PIN
####
0 0 0 0
(four zeros)
A four-digit user-settable PIN code to lock
the fixture.
Presets
Protected
No, 5 - 25
5 - 25
Determines if the factory Presets' Color
Mix is protected from changes.
Load Factory
No, Yes
No
Reload Factory Presets, Intensity changes
will also be reloaded.
DMX
Address
001 to 512
001
DMX512 address. Note, it can be set if
displayed.
Map
8-bit, 16-bit, or 5-Chan
16-bit
Defines size/precision of DMX map. Color
Mixing/Intensity in 16-bit provides higher
resolution for precision control. 5-Chan
provides minimal channel usage.
When no DMX
Off, Hold, Hold 10min,
Hold 30min, Hold 1 hr,
Hold 8hr, Power Up
Hold
If DMX is detected and then goes away,
this defines what will happen to the output.
At end of 8Hr hold Fixture goes to No
Output setting.
Display
Flip Display
No, Yes
No
Flips (inverts) Display and Keypad Arrows.
Adj Contrast
0 - 100%
50%
Use left or right arrow keys to adjust
display contrast as desired.
Fixture
Fixture ID
Shows Fixture Type - PLProfile4, Profile, Cyc, or
Fresnel
Shows luminaire type.
Summary of Contents for PLPF4MKII-03
Page 1: ......
Page 44: ...Installation User s Manual PLPROFILE4 MKII LED Luminaires 42 TECHNICAL SPECIFICATIONS Notes ...
Page 46: ......
