Installation & User’s Manual
PLPROFILE4 MKII LED Luminaires
1 0
INSTALLATION AND SET UP
5. Mounting
WARNING!
Before attempting any installation or service, disconnect all power at power source. Dimming the
luminaire does not disconnect power. Installation and service should only be performed by a trained and qualified
professional.
Using Supplied C-Clamp
As illustrated in
Figure 3 on page 10
, at yoke assembly, thread clamp mounting bolt (with washer installed) through
center clamp mounting hole at top of yoke, through Top Box Assembly, and thread bolt into C-Clamp. Securely
tighten bolt (by hand) into clamp (but do not over-tighten).
Figure 3: Luminaire Mounting
To mount on a telescopic stand, reverse the yoke under the luminaire and bolt to stand. Please note luminaire
orientation (see note in
Figure 3
).
Note:
After installing Clamp and Top Box assembly, connect luminaire cable assembly to Top Box Assembly before
mounting luminaire. Please note that the cable connector is keyed.
Yoke Assembly
Center Clamp Mounting Hole
Luminaire Cooling Vents
NOTE:
To allow for proper cooling, make sure
luminaire head is orientated as shown (with
cooling vents pointed upwards).
Top Box Assembly
C-Clamp
Flat Washer
C-Clamp Bolt
Top Box Assembly
Luminaire Cable
Assembly
Summary of Contents for PLPF4MKII-03
Page 1: ......
Page 44: ...Installation User s Manual PLPROFILE4 MKII LED Luminaires 42 TECHNICAL SPECIFICATIONS Notes ...
Page 46: ......
