Installation & User’s Manual
PLPROFILE4 LED Luminaires
2 4
OPERATION AND PROGRAMMING
Note:
To Exit the Settings screen, use the [ESC] key. [ESC] and [OK] can be used to cancel or save changes to an
individual parameter. However, once a parameter has been accepted, by pressing [OK] that change cannot be undone/
canceled by pressing the [ESC] key.
Presets
3
Protected
No, 5 - 25
Yes
Determines if the factory Calibrated
Presets' Color Mix is protected from
changes.
3
Load Factory
No, Yes
No
Reload Factory Calibrated Presets,
Intensity changes will also be reloaded.
DMX
3
DMX Enabled
No, Yes, or Wireless (if
equipped)
Yes
Enables or disabled DMX communication
through the luminaires DMX512 ports.
Sets the DMX feature to Wireless DMX (if
wireless DMX option is installed - sold
separately).
1
Address
001 to 512
001
DMX512 address. Note, it can be set if
displayed.
2
Map
8-bit, 16-bit, or 3-Chan
16-bit
Defines size/precision of DMX map. Color
Mixing/Intensity in 16-bit provides higher
resolution for precision control. 3-Chan
provides minimal channel usage.
2
When no DMX
Off, Hold, Hold 8hr
(8
hours)
, or Power-Up
Hold
If DMX is detected and then goes away,
this defines what will happen to the output.
At end of 8Hr hold Fixture goes to Power-
Up setting.
Fan
3
Normal / Quiet
Normal or Quiet
Quiet
Normal - Normal Mode Provides higher
cooling margin for thermally challenging
applications. Recommended for full power
(RGBW @ 100%) applications with large
and numerous changes in power. Quiet -
(Quiet Mode) Quite Mode is similar to
Normal mode, but it controls fan tightly to
reduce fan noise.
3
Max%
0 to 100%
100
Sets the maximum fan speed
3
Min%
0 to 100%
1
Sets the minimum fan speed
Display
3
Flip Display
No, Yes
No
Flips (inverts) Display and Keypad Arrows.
