Initial Operation
9
3 Initial Operation
Setting up the Device
You
can
position
the
device
so
that
it
lies
flat
on
a
table
in
front
of
the
projection
surface;
it
is
not
necessary
to
tilt
it
towards
the
projection
surface.
Connecting power supply /
Charging battery
1
Insert the small plug of the power supply into the
socket on the rear side of your device.
2
Plug the power supply into the mains.
3
During the charging process, the indicator light on
the side of the device will be red. When the battery
is fully charged, it will turn green.
4
Charge the built-in battery before using for the first
time for at least 3 hours. This will prolong the life of
the battery.
Initial Installation
1
Switch the device on using the on/off switch on the
side.
2
Turn the device towards a suitable projection sur-
face or wall. Note that the distance to the projection
surface must be a minimum of 0.5 meters and a max-
imum of 5 meters. Make sure the projector is in a
secure position.
3
Use the focus wheel on the top to adjust the image
sharpness.
4
Select the desired menu language using
.
5
Confirm with
à
.
CAUTION!
Mains Voltage at the Site of Installation!
Check whether the mains voltage of the
power supply matches the mains voltage
available at the setup location.
Note
The main menu appears instead of
the language selection
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1
Use the navigation keys to select
Set-
tings
.
2
Confirm with
à
.
3
Select with
Language
.
4
Confirm with
à
.
5
Select the desired language with
.
6
Confirm with
à
.
7
Exit with
.
