Mechanical Instructions
4.
4.3.7
Keyboard Control Panel
Refer to
.
1.
Unplug the connector [1] on the IR/LED board that leads to
the Local Control board, as it is not unplug-able at the Local
Control board itself (soldered connector).
2.
Release the cable from its clamps/tape.
3.
Put your thumbs against the front bezel [1] while pulling the
Local Control board in the direction of the arrows
When defective, replace the whole unit.
Figure 4-8 Keyboard Control Panel
4.3.8
LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the speaker as described earlier.
4.
Remove the stand as described earlier.
5.
Release the control board cable from its clamps and
unplug the control board cable from the IR/LED board.
6.
Remove the fixation screws that secure the LCD panel with
the bezel.
7.
Lift the LCD Panel from the bezel.
8.
Remove the fixation screws that secure the panel with the
Metal frame.
When defective, replace the whole unit.
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position.
See
and
.
•
Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
1
88
60_10
8
_100429.ep
s
100601
1
