on the appliance.
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
1
Make sure the appliance is switched off and disconnected from the
mains.
2
Remove the beard trimming comb.
3
Open the cutting unit (Fig. 10).
4
Clean the cutting unit and the inside of the appliance with the
cleaning brush supplied (Fig. 11).
5
Push the cutting unit back onto the appliance to close it
(‘click’) (Fig. 12).
Note: The appliance does not need any lubrication.
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1
Open the cutting unit.
2
Pull the old cutting unit upwards to remove it (Fig. 13).
3
Insert the two lugs of the new cutting unit into the guiding
slots (Fig. 14).
4
Push the cutting unit back onto the appliance (‘click’) (Fig. 12).
Environment
Do not throw away the appliance with the normal household waste
-
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment (Fig. 15).
The built-in rechargeable battery contains substances that may pollute
-
the environment. Always remove the battery before you discard and
hand in the appliance at an official collection point. Dispose of the
battery at an official collection point for batteries. If you have trouble
removing the battery, you can also take the appliance to a Philips service
21
TQT4019_EN.indd 21
11.12.8 10:53:33 AM
