Philips MCM510, User Manual

Page: 14 / 21

14
English
Radio Reception
Tuning to radio stations
1
Select
TUNER
source.
➜
“
TUNER
” is displayed briefly.
2
Press
BAND/DISPLAY
to select the desired
waveband : FM, MW or LW.
3
Press down on TUNING
S
/
T
(
à
/
á
on the remote control) and release the button.
➜
The display will show "
SEARCH
" until a radio
station with sufficient signal strength is found.
➜
If a FM station is received in stereo, is
shown.
4
Repeat step
3
if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
S
/
T
(
¡
/
™
on the remote control) briefly
and repeatedly until you have found optimal
reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory for each band.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM/PRESET
4
/
3
to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press
PROGRAM
for more than two seconds
to activate programming.
➜
All available stations are programmed.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press PROGRAM to activate programming.
➜
PROG flashes in the display.
3
Press
ALBUM/PRESET
4
/
3
to allocate a
number from 1 to 40 to this station.
4
Press PROGRAM again to confirm the setting.
➜
PROG
disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.
VOLUME
INCREDIBLE
SURROUND
PROGRAM
TUNING ALBUM PRESET
SOURCE
TIMER SET
DBB DSC
RDS
CLOCK SET BAND
STANDBY-ON
ECO POWER
RECORD DISPLAY
M C M 5 1 0 M I C R O S Y S T E M
iR
/
pg001-020_MCM510_22_Eng 2005.7.12, 17:11 14