34
English
3139 115 20961
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no key is pressed within
90 seconds, the system will exit clock setting mode
automatically.
Timer setting
The system can switch on to CD, TUNER or
CDR mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
1
Enter
timer setting mode
(refer to
“Clock/Timer setting mode”).
➜
The last wake-up source starts flashing
(
TUNER
,
CD
or
CDR
).
2
Adjust
MASTER VOLUME
to select the
sound source.
➜
Display sequence shows :
CDR
™
CD1
™
CD2
™
CD3
™
TUNER
...
●
Before setting the timer, make sure the sound
source has been prepared.
CDR
– load a CDR(W).
CD 1•2•3
– load the disc(s). To start from a
specific track, make a program (refer to “CD
Changer/Recorder Operations - Programming
the disc tracks”).
TUNER
– tune to the desired radio station.
3
Press
CLOCK/TIMER
(or
CLOCK
on the
remote control) to confirm the selection.
➜
The clock digits for the hours start flashing.
4
Repeat
step 3-6
of “Clock Setting” to set the
hours and minutes.
➜
"
TIMER ON
" is displayed and followed by the
set timer "
ATXX
:
XX
" and then the selected
sound source.
➜
ALARM
remains on the display.
●
At the preset time, the selected sound source
will play.
To exit without storing the setting
●
Press
Ç
on the system.
Notes:
– If the program mode is active, it will have the
priority over the selected disc track.
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no key is pressed within
90 seconds, the system will exit timer setting mode
automatically.
Checking the timer
●
Press
TIMER
once
on the remote control.
➜
If the timer has been activated, the set timer
information is displayed.
Activate/deactivate the timer
●
Press
TIMER ON/OFF
repeatedly on the
remote control.
➜
If activated, the last set timer information is
displayed for a few seconds,
ALARM
is shown.
➜
If deactivated, “
TIMER OFF
” is displayed.
Clock/Timer
pg 001-039/MC90/37-Eng
1/30/02, 8:59 AM
34