27
English
3103 306 18522
Timer setting
The system can switch on to CD, TUNER, or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1
Press and hold
TIMER
on the remote control
for more than
two seconds
.
➜
"
AM 12:00
" or "
00:00
" or the last timer
setting starts flashing.
➜
TIMER
starts flashing.
➜
The selected source will be lighted while
other available sources are flashing.
2
Press
CD 1•2•3
,
TUNER
or
TAPE
to select
the desired source.
●
Before setting the timer, make sure the music
source has been prepared.
CD 1•2•3
– Load the disc(s). To start from a
specific track, make a program (refer to “CD
Operation - Programming the disc tracks”).
TUNER
– tune to the desired radio station.
TAPE
– load a prerecorded tape.
3
Press
à
or
á
repeatedly to set the hour for
the timer to start.
4
Press
í
or
ë
repeatedly to set the minute for
the timer to start.
5
Press
TIMER
to store the start time.
➜
"
TIMER ON
" is displayed, followed by the
set timer "
XX:XX
" and the selected source.
➜
TIMER
remains on the display.
●
At the preset time, the selected sound source
will play.
To exit without storing the setting
●
Press
Ç
on the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
Checking the timer
●
Press
TIMER
on the remote control.
➜
If the timer has been activated, the set timer
information is displayed.
Activating/deactivating the timer
●
Press
TIMER ON/OFF
repeatedly on the
remote control.
➜
If activated, the last set timer information is
displayed for a few seconds,
TIMER
is shown.
➜
If deactivated, “
OFF
” is displayed.
Deactivating the wake up timer (five
minutes interval)
●
After timer wake up, press
SNOOZE
on the
remote control.
➜
The system will switch to standby mode for
five minutes. After that, it resumes the timer last
selected source again.
●
To cancel the snooze function, press
SNOOZE
again.
Note:
– You are only able to activate the Snooze
function within 30 minutes after timer wake up.
Clock/Timer
pg 001-032/MC77/37-Eng
4/16/02, 7:20 PM
27
