TRACKING
MUTE
REC/OTR
SPEED
MEMORY
0
8
9
7
5
6
4
2
3
1
PAUSE/STILL
ALT.CH
STOP
F.FWD
PLAY
REW
VOL.
STATUS/EXIT
MENU
POWER
SLEEP/WAKE UP
CH.
CLEAR
8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure batteries are in
the remote control and you have connected the TV/VCR
correctly.
The instructions on this page work only when you turn on
the TV/VCR for the first time.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS
B
TO END PRESS EXIT
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT
KL
OR
PRESS MENU TO CONTINUE
• If you do not see any on-screen
displays when you turn on the
TV/VCR, check your hookups, then
try again. If you still do not see
any on-screen displays, follow the
steps on pages nine-10 to select a
language and set up channels.
• To skip step 2, press the MENU
button. All on-screen displays will
be in English. To skip step 4, press
the STATUS/EXIT button.
Automatic Channel Setup will not
occur, and CHANNELS NOT SET
will appear on the screen briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode is channel 00.
When you select channel 00, A/V
IN will appear on the screen
briefly. Press the CH(annel)
o
/
p
buttons or the Number buttons to
select another channel.
Helpful Hints
1
Press the POWER button. The TV/VCR will
come on and the screen shown below will appear.
4
Press the F.FWD/
B
button to begin automatic
channel setup. The TV/VCR will memorize all avail-
able channels. When channels are set, CHANNELS
ARE SET will appear on the screen briefly. Then the
TV/VCR will go to the lowest available channel.
If you try to set up channels when there is no anten-
na or cable connected to the TV/VCR, programming
will appear to take place, but eventually a NO TV
SIGNALS ... message will appear on the screen.
Connect an antenna or cable to the ANT(enna) jack
on the TV/VCR, then press the F.FWD/
B
button
again. You may need to follow the steps on page 10
instead.
5
Use the CH(annel)
o
/
p
buttons or the
Number buttons on the remote control to
select a TV/VCR channel. Use the VOL(ume)
o
/
p
buttons to adjust the sound.
When you scan channels with the CH(annel)
o
/
p
buttons, only the memorized channels will be avail-
able. Use the Number buttons to select non-memo-
rized channels.
2
Press the PLAY/
K
button or the STOP/
L
but-
ton to select English or Spanish on-screen dis-
plays and menus.
3
Press the MENU button. The screen shown
below will appear.
1
2,4
3
5
MC132DMG/MC192DMG 3/22/02 1:21 PM Page 8
