5
Line
Neutral
Groumd
Camera Power Cord
Lower Right Fitting
Camera Power Cord
W9407406BE
CCD Camera
Wiring Color Codes
Wire Designation
Line
Neutral
Ground
Black
White
Green
Brown
Blue
Green/Yellow
Location
N. America International
Figure 6: Terminal Block Wiring
Pull excess wire out of the cradle assembly. Tighten the
fitting around the cable to create a liquid tight fit.
Note: LTC 9352/01 models do not contain a wiring
terminal block.
5a. LTC 9352/01 Models Only: Strip the power supply
cable ends by removing no less than 6 mm (0.25 in) and
no more than 8 mm (5/16 in) of insulation away from
the wires, making sure not to nick the wires. Insert the
loose end of the power supply cable through the lower
right fitting. Tie a figure-eight knot in the wire to
prevent strain on internal circuits. Connect the cable
directly to the terminal block located on the rear of the
camera. Crimp the ground wire to the ground lug
located on the reverse side of the cradle (if available).
6.
Pull the video cable through the top fitting on the end
cap. The fitting accepts cables with diameters from 2.9
mm (0.11 in) to 6.4 mm (0.25 in).
Attach a BNC connector to the video cable and connect
it to the camera. See Figure 7. Pull excess cable out of
the cradle assembly. Tighten the fitting around the cable
to create a liquid tight fit. Use the tie wrap (included)
to provide strain relief on the video cables at the exit
point.
CCD Camera
Rear Cap
Small Top Fitting
Cradle
BNC
Connector
Terminal
Block
W9407407AE
Figure 7: BNC Connection
7.
If installing a zoom lens, insert the lens control cable
through the lower left fitting of the end cap. Attach the
lens wiring to the lens mating connector (if supplied),
and connect to the lens. If a mating connector is not
available, connect directly to the lens cables. Pull any
excess wire out of the cradle assembly. Tighten the
fitting around the cable to create a liquid tight fit. See
Figure 8. Use the tie wrap to provide strain relief on
the lens control cable at the exit point.
If installing a fixed lens, go to step 9.
Lens Drive Connectors
(See Lens Specifications
For Proper Lens Connections)
Tie
wraps
Small Top Fitting
Lower Right Fitting
Lower Left Fitting
Breather Vent
REAR VIEW
TOP VIEW
Lens Control Cable
P/T Feed-Thru Cable
W9407408AE
Figure 8: Completed Wiring Diagram
8.
If using a pan/tilt with a feedthru cable, insert the
camera/lens function cable through the lower left fitting
of the end cap. The fitting accepts cables with diameters
from 1.8 mm (0.07 in) to 6.6 mm (0.26 in).
Wire the functions, as described above (steps 5-7), or as
needed. Pull any excess wire out of the cradle assembly.
Tighten the fitting around the cable to create a liquid
tight fit. See Figure 8. Use the tie wrap to provide
strain relief on cable at the exit point.
9.
Adjust the camera focus and iris if necessary.
10. Replace the cradle into the side rails and slide the
assembly into the housing until the end cap is securely
closed.
11. Replace the two (2) Phillips head screws and tighten.
12. Attach the housing to the appropriate mount or pan/tilt
using the instructions provided.
