Mechanical Instructions
4.
4.
Mechanical Instructions
Index of this chapter:
1.
Set Disassembly
2.
Service Positions
3.
Assembly/Board Removal
4.
Set Re-assembly
Note: Figures below may deviate slightly from the actual
product, due to different set designs.
4.1
Set Disassembly
1.
Remove all screws from the back cover (do not forget the
screws that hold the rear connection panel).
2.
Pull the back cover backward to remove it.
4.2
Service Positions
There are 2 service positions possible.
Family Board without bracket (with integrated 'control').
1.
Disconnect the strain relief of the AC power cord.
2.
Remove the mono carrier, by pushing the two center clips
outward [1]. At the same time pull the panel away from the
CRT [2].
3.
Disconnect the degaussing coil by removing the cable from
(red) connector 0212.
4.
Turn the panel 90 degrees counter clockwise [3].
5.
Flip the panel 90 degrees [4], with the components toward
the CRT.
6.
Turn the panel with its rear connections toward the CRT
[5].
7.
Slide the metal heatsink (near the mains transformer 5520)
underneath the right chassis bracket. This secures the
panel [6].
Figure 4-1 Service position (1)
Family Board with bracket (with separate 'control').
1.
Disconnect the strain relief of the AC power cord.
2.
Disconnect the degaussing coil by removing the cable from
(red) connector 0212 [1].
3.
Remove the panel bracket from the bottom tray, by pulling
it backward [2].
4.
Turn the chassis tray 90 degrees counter clockwise.
5.
Move the panel to the left and flip it 90 degrees [3], with the
components toward the CRT.
6.
Turn the panel with the rear jack panel toward the CRT.
7.
Place the hook of the tray in the hole in the cabinet bottom
[4] and slide the panel backward to lock it in the service
position.
Figure 4-2 Service position (2)
B
1
A
CL 16532016_007.ai
040401
3
6
4
5
1
1
2
A
CL 16532016_009.eps
220501
B
4
3
2
1
www.freeservicemanuals.info
22/11/2016
Published in Heiloo Holland
