Philips HU4811, User Manual

Page: 8 / 50

6 EN
Refill water
Water level can be observed through the
transparent water tank window.
1
Sw itch off the humidifier and unplug it
(fig j ).
2
Hold by both sides of the upper unit and
lift it up (fig b ).
3
You can observe the water level through
the transparent water tank window. Fill
the water tank with cold tap water until
the water reaches the maximum water
indication level (fig f ).
Note
•
When filling water, do not exceed the maximum
water level, or water might leak from the drain
hole and air inlets.
•
Do not shake the water tank when moving it,
or water might leak from the drain hole and air
inlets.
•
Do not fill water through the air outlets on top
of the humidifier.
4
Pl ace the upper unit back onto the water tank
(fig
g
).
5 Cleaning your
humidifier
Note
•
Always unplug the humidifier before you clean it.
•
When pouring water from the water tank, make
sure to pour water from the opposite side of
the drain hole and air inlets.
•
Never use abrasive, aggressive, or flammable
cleaning agents such as bleach or alcohol to clean
any part of the humidifier.
• It is normal to have dust inside upper unit of the
appliance after using it for a while. User cannot
clean it by himself. Please contact local service
center for support.
Clean the body of the
humidifier
Regularly clean the inside and outside of the
humidifier to prevent dust from collecting.
1
Wipe away dust with a soft dry cloth from
the body of the humidifier.
2
Clean the air inlet and the air outlet with a
soft dry cloth.
Clean the water tank
Clean the water tank every week to keep it hygienic.
1
Take out the humidification filter and the
filter support.
2
Fill the water tank for 1/3 with water.
3
Add some mild washing-up liquid to the
water in the water tank.
4
Clean the inside of the water tank with a
soft clean cloth.
5
Empty the water tank into a sink.
6
Put the humidification filter and the filter
support back into the water tank.