14
3139 115 2xxx1
English
Optional Connections
(continued)
IMPORTANT!
The progressive scan video quality is
only possible when using Y Pb Pr and
a progressive scan TV is required.
1
Use the component video cables (red/
blue / green - not supplied) to connect the
Junction Box’s
Y Pb Pr
jacks to the
corresponding component video input
jacks (or labeled as Y Pb/Cb Pr /Cr or
YUV) on the TV.
2
To hear the TV channels through this
DVD system, connect the audio cables
(white / red) from the Junciton Box to the
corresponding AUDIO OUT jacks on the
TV.
●
Do not connect the video cable from
Junction Box to your TV.
3
Proceed to pages 21~22 for detailed
Progressive Scan set up.
Connecting to a Progressive
Scan TV
Junction box
1
2
IMPORTANT!
If your TV only has a single Antenna
In jack (or labeled as 75 ohm or RF
In,) you will need an RF modulator
in order to view the DVD playback
on the TV.
1
Connect the composite video cable
(yellow) and audio cables (red/white)
from the Junction Box to the respective
input jacks on the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect the Antenna Input jack on your
TV to the antenna output jack on the RF
modulator.
3
Depends on your existing setup, connect
the antenna/cable TV signal from the
antenna wall outlet or Cable Box/
Satellite Receiver to the antenna input
jack on the RF modulator.
Helpful Hints:
– Set your TV to channel 3 or 4 if you are
using an RF modulator.
– See your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
Connecting to a single
antenna jack TV
Junction box
Back of an RF Modulator
(Example only)
antenna/cable TV
signals
2
1
3
001-053-hts8000-37-Eng14a
7/2/05, 10:20 AM
14
