DISASSEMBLY INSTRUCTIONS
Dismantling the Front panel & Speaker Driver
1. Place the Subwoofer Box up side down as shown in the
Picture 1 and use a flat-head screwdriver to gently force
open the plastic front panel. (Start at the arrow locations)
Panel of Subwoofer.
Picture 1
Dismantling the Front Assembly
1. While opening the front panel, a 3-wire cable has to be
disconnected between the box and the panel LED
assembly.
2. Place the Subwoofer Box as shown in the Picture 2
and loosen 4 screws to remove the Speaker Driver.
Picture 2
Dismantling the Rear Assembly
1. Loosen 10 screws as shown in the Picture 3 (Rear
View) to pull out the Printed Circuit Board assembly.
Caution: Take care the surface when take out the front
panel of subwoofer.
WARNING: THERE IS ONLY A LED BETWEEN
THE FRONT PANEL AND WOOD BOX. IF NOT
NECCESSARY, PLEASE DON’T TRY TO OPEN THE
FRONT PANEL!!!
Picture 3
Summary of Contents for HTS3455/51
