Philips HTS3355, Service Manual

Page: 12 / 35

3 - 1 3 - 1
Figure 8
Figure 9
DISASSEMBLY INSTRUCTIONS
3) Loosen 7 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear.
- 1 screw “A” each on the left & right side as shown in fi gure 4
- 5 screws “B” at the back panel as shown in fi gure 5
4) Loosen 1 screw “C“ each left & right side on the front panel after move the top panel as shown in fi gure 6.
5)Loosen 6 screws “D” at bracket of front panel as shown in fi gure 7
A
Figure 4
B
Figure 5
Dismantling of the AMP Board
1) Loosen 4 screws to remove the AMP Board.
- 2 screws “ E “ on the top of AMP board as shown in fi gure 8
- 2 screws “ F “ at the back panel as shown in fi gure 9
Push
24mm
m
m
2
Figure 1
Figure 3
Figure 2
Dismantling of the Front Panel Assemble
1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray
Cover.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in fi gure 2 . Place the set on its
side, insert the mini screw driver till the marking and slide it towards the right as shown in fi gure 1 until the Tray moves out of the
Front Panel.
2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back
in.
C
Figure 6
D
Figure 7
E
F