DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 3 of 3
Periodic Maintenance
Periodically inspect all fasteners associated with the mounting system. Tighten or adjust fasteners as necessary for
optimal operation and safety.
Cleaning the Mounting Assembly
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Do not use Steel wool or other abrasive material.
4. Damage caused by the use of unapproved substances or processes will not be warranted. We recommend testing of
any cleaning solution on a small area of the mounting assembly that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off of the mounting
assembly immediately using a water-dampened cloth. Dry the mounting assembly thoroughly after cleaning.
CAUTION:
GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
Base
Column
#10-32 x 9/16''
FHMS (3)
Manual Tilt
Clamp
#10-32 x 5/8''
FHSCS (3)
#10 x 1-1/2''
FHSMS (3)
Pic 6
Pic 5
Pic 4
#10 x 1-1/2
FHSMS (3)
#10-32 x 5/8''
FHSCS (3)
#10-32 x 9/16''
FHMS (3)
Pic 2
Pic 3
Pic 1
Swivel Head
Roll Stand Post
