6
Before you start dismantling!
For your safety be sure the plug is
disconnected from the mains!
The product is designed for easy access to the
internal components.
Make sure that all accessories like tank, podholder,
drip tray, spout and collector have been removed.
During assembly
•
Make sure that the wiring is properly dressed as
in the original situation. When replacing crimp
connections or tie wraps, perform a pull test.
Prevent entrapment of wiring between housing-
or internal parts.
•
Make sure that all parts are re-assembled, and
that no parts are forgotten. E.g.: sleeves, internal
protection caps, screws.
•
Make sure that the housing parts are properly
assembled. No gaps should be present, yet
make sure screws are not overturned.
After assembly:
•
Check all relevant functions of the appliance.
•
Check if the consumer complaint has been
resolved.
•
Check for abnormalities. E.g.: leaking liquids,
smoke, smell, abnormal noise.
•
Check the use safety functions. E.g.: lid-open
detection switch, motor disable switches.
•
Check the electrical safety functions:
- leakage current
- high voltage (servicer to perform a test)
- earth continuity (servicer to perform a test)
Disassembly information
To remove the back cover, follow below steps:
•
Remove the two Torx screws (T15)
A
(see
exploded view).
•
Remove the valve outlet.
•
Start at the upper side of the back cover, using
a flat head screwdriver to unhook the top of the
back cover and gently pull the back cover from
the appliance so that a little chink between back
cover and brew chamber becomes visible.
•
Again use the screwdriver to unhook the two
“snap locks” at each side of the back cover, and
gently move the screwdriver in the direction of
the opposite side of the appliance, in such a way
that the lips of the snap locks are bent outwards
and unhook.
•
If all snap locks are unhooked, it is possible to
remove the back cover. Gently pull the back
cover upwards to release the bottom part of the
back cover from the housing. Please note that
the back cover is still connected to the pump.
•
For reassembly follow these steps backwards.
To remove the brew chamber lid cover, follow
below steps:
•
Place a large screwdriver
on the positions (see
picture 1) and lift the
cover over the snap
locks on both positions,
use appropriate force.
•
The cover lid can now be
lifted up, but stays
attached to the brew
head by the push rod, to
remove the complete
cover including lever and
push rod squeeze both
legs of the push rod
strongly together
(see picture 2), so that the two pins will unhook
out of the hinge position on the brew chamber.
picture 1
picture 2
Disassembly- and Reassembly advice
